Basic Info

Muhammad AbdEl-Azim

3 years

Cairo, Egypt

Bachelor's Degree

Experienced

Work Experience

Project Engineer at Enviro-civec (بيت خبرة)

Experience Details

Project Engineer

Engineering - Mechanical/Electrical, Engineering - Other

Experienced (Non-Manager)

JOB DESCRIPTION:
My chief responsibility would be to iron out all the hurdles that would delay a project from completion. Whether these hurdles originate from the client (owner) side or contractor side. Aside from the prior responsibility other responsibilities can be summarized into:

• Producing calculation sheets for pumps, sumps, generating sets…etc.
• Producing tender documentations (specifications, drawings...etc.)
• Producing workshop drawings.
• Designing and selection of pumps, sumps and generation sets.
• Reviewing technical offers for mechanical works.
• Reviewing tender documentations.
• Coordinating with the contractor to achieve a timely and orderly delivery of the project.
Notable projects within my responsibility:

Marsa Matrouh waste water pumping stations rehabilitation

The old wastewater networks as well as the stations established in the 90s were being flooded in the summer with the influx of vacationers, the potable water and Wastewater Company of marsa matrouh employed us to study rehabilitate the stations and the network.
My responsibility was to gather onsite data, evaluate the status of installed pumps and other equipment and finally, prepare a report of the current situation and whether it is beneficial to increase the capacity of the installed pumps or construct a new pump house.

6th of October intake and booster stations (1,700,000 m3/day)

My responsibility was to provide the second stage tender documents for the project, what made this project special was the sheer volume of water required to be transported as well as the attention to even the smallest details in order to ensure the best results.

Al laith , Adam and Al konfeza governate water pumping station (K.S.A.)

Employed as the owner consultant, we were given the responsibility of designing and providing the tender documents for the water networks and carrier lines to the three governates. I was n direct responsibility of designing 6 of total of 11 water pumping stations approved for design by the owner.
Chief among the stations designed the following proved a challenge to design:
(sabt al gara) online pumping station (5 l/s, 70 m).
(Booster pumping station 2-A) pump station (50 l/s, 470 m)

Enhancing the efficiency of sand and scum treatment facility - Abu rawash WWTP

Employed as the contractor consultant, we were tasked with reprimanding the claims by the owner (NOPWASD) that the sand and the scum treatment facility was operating below desired efficiency levels, after a site examination it was determined that the position of the sand lift pumps and the movement of the bridge holding it caused a dead zone in the far end of the tank, a solution was proposed to the contractor that the sand lift pumps suction pipes should be moved from its current location in the center of the sand scrubbing bridge to the far end of bridge. Thus, removing all the accumulated sand in the dead zone.


Al-Nubaria waste water pumping stations rehabilitation

Three waste water pumping stations in the Nubaria province were in need of rehabilitation as well as a single ground water station that the authority of water and sewage in beharya requested to retrofit it into a sewage pumping station. My responsibilities were to gather on-site data, evaluate installed equipment, provide solutions for broken down equipment and compile those findings into reports.
The challenge in this task was in one of the stations (second industrial) was in such a bad condition that it had to be isolated and bypassed in order for the network to operate properly.
The entire station facilities were flooded with industrial sewage (both the 9 m deep sump and the pump house) up to the ground level.
The entire inlet header and the discharge header were corroded as well the cardan shaft vertical pumps inside and out. In addition to that the ground has sunk and is uneven throughout the station this presented a unique situation that has sheared the cast iron inlet pipe from the network to the sump.
In order to address those challenges an investigation needs to be performed on a material that able to withstand prolonged chemical exposure from yeast, textile and fertilizer industries.


Company Details

Enviro-civec (بيت خبرة)

Cairo, Egypt

51-100 employees

Engineering Services, Energy and Utilities, Environmental Services

N/A

Sep 2015 to present (2 years 3 months)
Project Engineer at Consolatory office for sanitary and environmental engineering – Dr. Medhat saleh / SEECO

Experience Details

Project Engineer

Engineering - Mechanical/Electrical

Entry Level

My chief responsibility would be to iron out all the hurdles that would delay a project from completion. Whether these hurdles originate from the client (owner) side or contractor side. Aside from the prior responsibility other responsibilities can be summarized into:

• Producing calculation sheets for pumps, sumps, generating sets…etc.
• Producing tender documentations (specifications, drawings...etc.)
• Producing workshop drawings.
• Designing and selection of pumps, sumps and generation sets.
• Reviewing technical offers for mechanical works.
• Reviewing tender documentations.
• Coordinating with the contractor to achieve a timely and orderly delivery of the project.

Notable projects:

- Final seeb station WWPS - Al-hamam - Marsa matrouh (wet sump)

- Al-sharqia sewage deprived villages : Al-maysa'a , Debyg , Keshk settelment
( wrokshop drawings creation and final sump design for construction )

- Al abasya and Al ebrahymya al bahrya - Dameitta

- Al-ayat WTP - Giza ( 2nd stage )

- Al hamam filteration, irrigation and tanks station - Marsa matrouh
A filtration and pumping station equipped with equalizing tanks for storage and pressurized filters for irrigation utilizing drip irrigation

The following projects I was responsible for through reviewing and approving equipment :
- New dammitta intake and kafr soliman water pumping station - damitta :
Vertical pumps w/ cardan shaft , ventilators , cranes


Company Details

Consolatory office for sanitary and environmental engineering – Dr. Medhat saleh / SEECO

Cairo, Egypt

11-50 employees

Environmental Services , Engineering Services

N/A

May 2015 to Sep 2015 (4 months)
Mechanical Maintenance Engineer at International company for consulting and trading (ICAT) - O&M branch

Experience Details

Mechanical Maintenance Engineer

Engineering - Mechanical/Electrical

Entry Level

Overseeing a team of technicians to perform our duties. As well as Performing daily maintenance and checkups. This is coupled with the performance of corrective maintenance and preventive maintenance if needed to retain an acceptable level of operation of the station. In addition to those general responsibilities, I'm responsible for the following:

•Inspection, troubleshooting and maintenance of the following equipment: screens, positive displacement pumps, centrifugal pumps, blowers and grit removal bridges.

•Performance of half-overhaul to inlet pump station pumps.

•Basic troubleshooting and maintenance to valves and valves auxiliary equipment.

•Pipeline troubleshooting and maintenance.

•Following grease and maintenance schedules.

•Bearing removal and installation.


Company Details

International company for consulting and trading (ICAT) - O&M branch

Cairo, Egypt

51-100 employees

Engineering Services, Environmental Services

http://www.icat.com.eg/

Oct 2014 to May 2015 (7 months)
Mechanical Engineer (intern) at Consultant Office for Sanitary & Environmental Engineering/Seeco

Experience Details

Mechanical Engineer (intern)

Engineering - Mechanical/Electrical

Student

Gains:

•Trained in the design of sewerage pumping stations.
•Trained in the calculations of design of discharge lines and pumping stations.
•Trained in reviewing technical offers and the criteria for acceptance or rejecting them.
•Reviewed technical offers offered by: giza systems, almqawlon alarab and more.
•Designed a sewage pumping station situated in" Al-reqa el bahrya " village.


Company Details

Consultant Office for Sanitary & Environmental Engineering/Seeco

Cairo, Egypt

11-50 employees

Environmental Services , Engineering Services

N/A

Jul 2013 to Aug 2013 (1 month)
Mechanical Engineer (intern) at The arab contractors - Alameryah waste water pumping station site

Experience Details

Mechanical Engineer (intern)

Engineering - Mechanical/Electrical

Student

Gains:

• Learnt about the waste water pumping station system and other systems.
• Learnt about waste water station management and control system.
• Participated in pipeline field installation.


Company Details

The arab contractors - Alameryah waste water pumping station site (multinational)

Cairo, Egypt

More then 1000 employees

Energy and Utilities, Engineering Services, Engineering Services

N/A

Jul 2012 to Aug 2012 (1 month)
Mechanical Engineer (intern) at Central agency for drinking water and sewage - Al-amyryah water treatment plant

Experience Details

Mechanical Engineer (intern)

Engineering - Mechanical/Electrical

Student

Gains:
• Learnt about the water station system and other systems.
• Visited “Mostorod” water processing plant.
• Learnt about water station management and control system.
• Participated in pipeline field repair.


Company Details

Central agency for drinking water and sewage - Al-amyryah water treatment plant

Cairo, Egypt

More then 1000 employees

Engineering Services, Environmental Services

N/A

Jun 2012 to Jul 2012 (1 month)

Education

BSc in Mechanical power engineering

Education Details

BSc

Mechanical power engineering

Helwan University, Egypt

C / Good / 65 - 75%

N/A

N/A

Helwan University
2009 - 2015
This profile is not updated!
Last update more than 2 months ago.

Jobseeker photo

Profile Skills and Keywords

AdaptiveArabicAutoCAD 2DAutocad 3DCreativeEnergy And UtilitiesEngineering ServicesEnglishEnvironmental ServicesFlexibleHard WorkerInfrastructureInnovativeInstallationMaintenanceMechanical EngineerMechanical EngineeringMechanical Maintenance EngineerMechanical Power EngineeringMicrosoft OfficePowerful MangementProblem SolverProject EngineerRespectful & Fair TreatmentTechnical Office Related WorkThe Arab Contractors - Alameryah Waste Water Pumping Station SiteTolerance Regarding EmployeeWorking In A Team

Self-assesed Skills

Languages

Arabic

Arabic

: Fluent

: Fluent

: Fluent

: Fluent

English

English

: Fluent

: Fluent

: Fluent

: Intermediate

Tools and Technologies

Microsoft Office

Microsoft Office

: Advanced

: High

:

3-5 years

AutoCAD 2D

AutoCAD 2D

: Advanced

: Extreme - I love it!

:

1-3 years

Autocad 3D

Autocad 3D

: Intermediate

: Medium

:

1-3 years

Fields of Expertise

Infrastructure

Infrastructure

: Advanced

: Extreme - I love it!

:

1-3 years

Mechanical engineering

Mechanical engineering

: Intermediate

: Extreme - I love it!

:

Less than 1 year

Maintenance

Maintenance

: Beginner

: High

:

Less than 1 year

Technical office related work

Technical office related work

: Beginner

: Extreme - I love it!

:

Less than 1 year

Installation

Installation

: Little knowledge

: Medium

:

Less than 1 year

Key Skills

Hard worker, Creative, Problem Solver, Flexible / Adaptive, Innovative

I’m looking for work, please share my profile…

Get Your own Wuzzuf Profile Now !

Employer? If you're representing an organization or an enterprise, Signup here for FREE to see Muhammad's full profile and find more great talent and professionals to join your team.